ShopMotherEarth.................Naturally

earth

ShopMotherEarth

..........Naturally

With a rotor diameter of 2.5 meters (8.2 ft) and a peak output of approximately 1,600 watts the XL.1 is intended for the off-grid home market in the U.S. and for rural programs in developing countries. It is also a perfect upgrade system for current owners of micro-turbines, such as the Air 303 or 403.

For Bergey XL.1 1kW turbines. Includes a non- freewheeling worm-gear winch, a special bracket system for attaching the winch to a guy anchor, a pull-up cable, and a pulley block. Also includes a drive attachment for cordless drills.

A wind power breakthrough, Skystream 3.7™ is the first residential wind appliance to make energy at a cost of ($.09/kWh). That is lower than the retail rate of many electric utilities. Depending on the tower and installation costs, wind speed average, rebates and local electricity costs, Skystream 3.7 can pays for itself in as quickly as 4 years.

Includes a 9 foot Air Marine Aluminum Pole and 2 stays

This is an isolation mount designed to be used with the roof mount tower kit for AIR403. (Roof seal not included)

This roof top tower mount kit is designed for single or multiple AIR wind generator systems. These easy, low cost mounts can be installed through the roof or on the side of the building. These kits are designed with effective built-in vitabration isolation mounts. Optional roof seal available.

This tower installs in 2 hours or less! The EZ™-Tower is designed for winds up to 110 mph.Everything needed is included except for the power wire. The entire kit ships in 74" box, and it only weighs 65 lbs.

This is the Optional Roof Seal only!

The Telescoping Tower for Air X lets you quickly install your 400 W Air X Wind Generator on a 7 - 20 foot telescoping tower. Great for power needs in remote sites. Quickly connects to your vehicle in less than 15 minutes and folds down to a compact shape for storage.

Guyed towers are the standard for simple and durable tower installations. These towers tilt-up for easy installation. All parts are threaded, so no welding is required. All parts are included except the 1.875" steel pipe. The AIR™ requires a 1 ï¿½" pipe for the last 3 feet.

The 45 foot Guyed Tower Kit installs a few hours and includes everything needed except pipe and anchors.

These augers have a "U-shaped" channel with 2 square holes on each "upright" that allow a bolt/nut to be passed through the channel. The bolt that goes through the channel needs to also "capture" the thimbles of the guy wires. The bolts then attach the guy wire sets to the auger.

These Air Marine tower Kits are designed to simply install the AIR Marine wind generator system. They come with viabration reduction and are all Stainless Steel. The mast is White Powder-Coated Aluminum only. For a complete tower installation, order the Mast/Pole Set and a Hardware Kit, or if you have your own mast and stays, order only the Hardware Kit.

Quality